Parts for a Rowing Mechanism

Tue, 20 May 2014

I’m planning on adding a set of wave on the sides of the the rowing project I’m currently working on.

I have a single drive point at the end of the waves, the slot in the middle allows them to rock up and down. I’ve stacked two layers of waves out of phase with each other, the result is quite pleasing.

The drive pin is in the foreground of the this picture with the alignment pin in the distance.

Check it out in animated action.

  To receive new blog posts by email

Comments (3)

  • Smelter May 21, 2014 at 3:54 am

    As I commented on your
    As I commented on your Instagram picture, very Baron von Munchausen.

  • cool022883 May 21, 2014 at 5:15 pm

    are you doing the rowing
    are you doing the rowing project you originaly designed the tripple crank mechanism for?

  • ritama December 2, 2014 at 4:06 am

    Have you ever made a paper

    Have you ever made a paper version of this? I would love to create the waves in paper but I can't quite figure it all out from the PDF. Thank you!

Comments are closed.