See the Membership page for more details.
Already a Member? Log in Here
After I'd completed the Flying Cow project I had a spare cow head just lying around doing nothing. "Trophy Cow" I thought. And so, without further ado, I present this special, members only download. It fits on a single page and only takes a few minutes to do but the result is quite cute I hope you'll agree.
Print out the colour or mono version onto a single sheet of thin card (230 micron / 67lb) Score along the dotted and dashed lines then carefully cut out the pieces.
Starting from the top of the shield, fold over and glue down the tabs to make a right angled triangle. After the top, fold down and glue the two sides then the four sections of the curve.
Complete the shield by adding the hanger as shown above.
Fold up and glue together the neck.
Assemble the head and the horns
Glue the horns to the head, glue on the eyes then glue the fringe into place.
Glue the neck to the grey area on the shield.
Complete the trophy by adding the head to the neck.
Find a suitable place to hang your trophy cow.
Rate this post: